Walterscheid® Safety guard half outer SDFH 25 - 1116565

Walterscheid® Safety guard half outer SDFH 25 - 1116565

Product number: 1116565

SDFH25SW A1000 852562 WW ***


Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability. Cross references, designation of type by vehicle manufacturers or competitors are for guidance only. Check that the part is correct for the application before fitting.

Outer safety guard half for standard wide-angle drive shaft size WWE2380 | WWZ2380 with flexo funnel

Product advantages

The SD guard complies with worldwide safety regulations and takes into account additional radial loads during test requirements according to ISO 5674 and France Decree 81293. A guard funnel with support ring and retaining chains prevents the guard tubes from spinning. Due to the special arrangement of the guard, the joint is fully protected in all angular positions. Even with large angulations, no contact with the rotating joint occurs.
The scope of delivery includes a complete Walterscheid protective half consisting of 1x protective tube half, 1x flexo funnel, 1x sliding ring and 3x screw for protective funnel.
Type
SDFH
Size
25
Manufacturer
Walterscheid
Trichtertyp
FLEX
Trichter-SNR
134847
Schutzgröße
25
Protective colour
SCHWARZ
KPL/TKPL
KPL
WW-Typ
WW2380/2480/2580
J/A
A
Rohrlänge
1000.00
Drawing
85.220
Guard type
SDFH
Comer Industries Logo

© 2025 - Powertrain Rockford Inc. Product finder – v1.1b | Powertrain Rockford Inc. | We reserve the right to make design changes. Only use products for the intended purpose. We only accept responsibility for consistent quality. Reprints whether in whole or in part are only allowed with the written permission of Powertrain Rockford Inc..

Notify me when available

You will be notified as soon as the article is available again.